Operate the automatic feeding mixer, understand its advantages and scope of application, and formulate a reasonable operation plan. Self loading automatic loading mixer and large mixer adapt to completely different roads from all corresponding industrial and mining areas. However, these two different product application scenarios cannot be put together to share a common operation and mode. The profit model can not be to enter the rural roads, because the large mixer is too large and heavy, and the self-contained concrete mixer can better transport the commercial concrete to the rural roads.
In addition, because the manually mixed concrete is time-consuming and laborious, and the actual cost is almost the same as that of commercial concrete, it is important that the grade of manually mixed concrete cannot be guaranteed, but this is only a key point compared with commercial concrete. Therefore, the vast majority of concrete transported by self fed concrete mixers nationwide is 20-50 yuan higher than that transported by large mixers. Therefore, the operation mode of self loading automatic loading mixer should be carried out when the market competitiveness of township concrete distribution is almost blank. Under normal circumstances, it is very reasonable to increase 20-50 yuan to balance the demand and the price between the seller. This is the correct mode of self loading concrete mixer. Automatic feeding mixer has obvious price advantages and less investment. Good dispersion; The automatic feeding mixer completely solves the problems of poor uniformity and dead angle caused by different specific gravity of materials.
The automatic feeding mixer adopts the five axis mortar mixing structure with flying knife, which can better disperse all kinds of short fibers. Easy to use; The automatic feeding mixer has the advantages of small floor area, simple operation and low energy consumption.
Widely used; The automatic feeding mixer can meet the production of dry powder mortar with different performance requirements. For example: masonry mortar, plastering mortar, polymer mortar required for thermal insulation system, polystyrene particle mortar and other dry powder mortar. Long service life; All vulnerable parts of the equipment are made of high-strength wear-resistant steel, which has the characteristics of long service life.
The reason why the self feed mixer mixing equipment has such a wide range of applications is that the operating conditions of the mixing equipment can be controlled in a wide range. Automatic loading mixer can be divided into mechanical mixing and air mixing in many occasions. Air flow stirring is to use gas bubbles to stir the liquid through the liquid layer, or make the bubble group rise in a dense state, and make the convective circulation of the liquid faster through the so-called rising effect. Compared with mechanical stirring, the liquid stirring only through the action of bubbles is relatively weak, which is difficult to be used for liquids with thousands of millipascals or higher viscosity. However, air flow stirring has no moving parts, so it is more convenient to handle the stirring of corrosive liquid and reaction liquid under high temperature and high pressure. In industrial production, most mixing operations are mechanical mixing, with medium and low pressure vertical steel vessels as the main mixing equipment. The mixing equipment is mainly composed of mixing device, shaft seal and mixing tank. Mixing equipment is widely used in industrial production, especially in the chemical industry. Many chemical production adopt mixing operation more or less.
The above is a detailed introduction to the automatic feeding mixer. I hope it will be helpful to you If you have any questions, please contact us We will provide you with professional service http://www.aqtop.com/